CAN-BUS Shield Category_Sensors/Contact Employing a 3-axis magnetometer

Employing a 3-axis magnetometer

The board cab be powered by a lithium battery or through USB cable

The flexibility in input voltage offered by this family of regulators is especially well-suited for battery-powered applications in which the battery voltage begins above the regulated voltage and drops below as the battery discharges

accepts 0 V to 5 V on RX

3 V) to turn off the output and put the board into a low-power state that typically draws 20 μA

CAN-BUS Shield Category_Sensors/Contact Employing a 3-axis magnetometerThe CAN BUS Shield provides your Arduino or Redboard with CAN BUS capabilities and allows you to hack your vehicle. This shield allows you to poll the ECU for information including coolant temperature, throttle position, vehicle speed, and engine rpms. You can also store this data or output it to a screen to make an in dash project. It uses the Microchip MCP2515 CAN controller with the MCP2551 CAN transceiver. CAN connection is via a standard 9 way