Large Surface Transducer with Wires - 4 Ohm 5 Watt CANBUS Easily for assembling to the

Easily for assembling to the chassis

When the PMODE pin is left high-impedance (ie floating or disconnected) when the driver is enabled

including four selectable sensitivity (gain) settings

Sabertooth also allows you to make very fast stops and reverses - giving your robot a quick and nimble edge

(See the Sample Code section below for an Arduino library that can be used to turn this sensor into an altimeter

Large Surface Transducer with Wires - 4 Ohm 5 Watt CANBUS Easily for assembling to theTurn any surface wall table etc into a speaker with a surface transducer. This type of speaker does not have a moving cone like most speakers you've seen. Instead, a metal rod is wrapped with the voice coil. When current is pulsed through the coil, the magnetic field causes a piece of metal to expand and contract and if it's pressed against a surface it turns the transducer into a speaker! Often these size transducers are pressed up against a flat