SparkFun Altitude/Pressure Sensor Breakout - MPL3115A2 Category_Servos/Analog R/C Servos you should label the MD25

you should label the MD25 with its address

The core of this kit is built around the Pico4ML TinyML Dev Kit from Arducam

you have to stick the measurement resistor between the target ground and true ground

Arduino Uno Form Factor

or 57600 baud

SparkFun Altitude/Pressure Sensor Breakout - MPL3115A2 Category_Servos/Analog R/C Servos you should label the MD25Life has its ups and downs, so why not measure them? The MPL3115A2 is a MEMS pressure sensor that provides Altitude data to within 30cm (with oversampling enabled). The sensor outputs are digitized by a high resolution 24 bit ADC and transmitted over I2C, meaning it\'s easy to interface with most controllers. Pressure output can be resolved with output in fractions of a Pascal, and Altitude can be resolved in fractions of a meter. The device also