TPM - Wash Solvent - 5L 3DE ASA+ - 1.75mm Desuden giver den dig alle

Desuden giver den dig alle de nødvendige data til optimal styring af alle processer og indstillinger

* Installs much easier than masking tape and film typically used and with less chance of air bubbles

*On-screen help

3M tape and many other materials - see our selection here

*Printer med bemærkelsesværdige fine detaljer

TPM - Wash Solvent - 5L 3DE ASA+ - 1.75mm Desuden giver den dig alleWash Solvent TPM Wash Solvent (Tripropylene glycol monomethyl ether) is a non flammable, low odor solvent that can be used to clean and dissolve uncured resin on SLA DLP 3D printed parts. TPM has a lower evaporation rate than IPA and washes about three times as many parts as IPA before it needs to be replaced. * Compatible with Formlabs Finish Kit, Form Wash and Form Cure * 5 litres ! ATTENTION ! TPM is not currently certified for use with Formlabs